Starting on the circuit board, apply a continuous bead of COMP-HOLD over the top of the component and end on the circuit board, anchoring the electrical part from two (2) sides. If a long string of components is lined up (in parallel), apply the COMP-HOLD over the top of each component anchoring both ends to the circuit board. While the COMP-HOLD remains wet, you can make small adjustments to the components as necessary. Once dry, the electronic parts will not rock, float or tilt out of place during the wave solder application.
Active Ingredients: Non-Ionic ResinsViscosity: 45,000 CPSState: Thick PasteSolubility (Water): 100%Soluble Water Temperature: 140°F (60°C)Color: Brown/YellowSolids Content: 51%Alkalinity: pH 7.0Storage Temperature (Un-Opened Container): Room Temperature [72°F (22°C)]
![Contronic Devices 3508 COMP-HOLD [8oz. Non-Ionic Water-Soluble Component Hold]](assets/templates/common-core/images/spacer.gif)
[ITEMPRICE]
